Download Document

How do I configure a VCC unit for my network?

Answer:

To accomplish the task of configuring the VCC unit, the “Parameters card” that was shipped with the VCC unit has to be readily available.  To begin this process, swipe the parameters card. 

Use the arrow keys in the top right hand corner to navigate.

Screen 1       Enter Off-Line

                        Set IP

Using the arrow keys, Select Set IP

Hit the Enter Key

Screen 2       BootP Static IP       

Using the arrow keys, select Set Static IP

Hit the Enter Key

Screen 3       Controller IP

Using the Number Pad, enter the Controller IP for this unit

Hit the Enter Key

Screen 4       SUBNET MASK

Using the Number Pad, enter the subnet mask for this network

Hit the Enter Key

Screen 5       Server IP

Using the Number Pad, enter the Server IP

Hit the Enter Key

Screen 6       Gateway IP

Using the Number Pad, enter the Gateway for this network

Hit the Enter Key

Screen 7       Reader Port

The default is displayed

Hit the Enter Key

Screen 8       Controller Port

The default is displayed

Hit the Enter Key

To complete the configuration process, hit the enter key  .  When the VCC has been successfully configured on the server, the unit will display “Please enter Acct# or Swipe Card”.

However, if the unit does properly initialize, verify that the OCS service is running on the server, and confirm that the data entered on the OCS Server matches the data entered into the unit.